Model Building Corner Clamp

Getting a good 90-degree joint can be a challenge when building structure kits. This corner clamp kit provides a snug fit without so much pressure that it distorts the model. 

The jaws are 1" tall and will secure a typical N or HO scale structure corner. Use two clamps for larger scales - one at the top and bottom. The jaws have clearance gaps to prevent glue from adhering, although a strip of masking tape is suggested to guard against any excess glue use.

Available in 3 options:

• 4-Clamp Set - a complete set of 4 clamps with corner jaws AND flat jaw pads.
• 2-Clamp Set - a complete set of 2 clamps with corner jaws AND flat jaw pads.
• Jaws Only - set of 4 jaws (2 inside, 2 outside) sized to fit a common 4" bar clamp that has a jaw size of 0.6" wide and 0.1" thick. 
  Jaw sets are not returnable - be 100% sure that your clamps are the correct size before ordering.

The clamp sets include two or four 4" light-duty bar-clamps, flat jaw pads, and 90-degree corner jaws. Clamps can be reversed to apply outward pressure. Clamps should be closed manually and then apply ONE trigger-pull to set the correct tension.